Met Laboratories And Qai Laboratories Are Examples Of
Question: Today, the NEC* is administered by the __________.
Answer: NFPA
Question: The internet address to submit input for the National Electrical Code* is ___________.
Answer: www.nfpa.org/70
Question: Two organizations working toward the globalization of electronics standards are _______.
Answer: IEC and IEEE
Question: Information on calculating branch circuit loads can be found in ________.
Answer: NEC Article 220
Question: Where in NEC Article 406 can you find information on installing receptacles in damp or wet locations?
Answer: NEC Section 406.9
Question: The first edition of the NEC was published in _______.
Answer: 1897
Question: The NEC safeguards people and property from the hazards of electricity by establishing minimum installation________.
Answer: Requirements
Question: Proposed changes to the NEC can be submitted by__________.
Answer: Anyone
Question: What year did the NFPA begin publishing the NEC?
Answer: 1962
Question: MET Laboratories and QAI Laboratories are examples of___________.
Answer: Nationally Recognized Testing Laboratories
Question: What is the BEST way to submit changes to the NEC?
Answer: Use the form available on the NFPA website
Question: IEC and IEEE are collaborating to__________
Answer: Globalize electronics standards
Question: What are the types of rules contained in the NEC?
Answer: Mandatory and permissive
Question: Informative Annexes A - J contain information__________.
Answer: Related to non-mandatory topics
Question: NEC Chapter 8 contains information on__________.
Answer: Communication systems
Question: NEC Article 200 contains__________.
Answer: Information on grounded conductors
Question: NEC Article 100 contains________.
Answer:
Question: The section in the NEC where it specifies that nonmetallic-sheathed (NM) cable must be supported within 12" of every box or cabinet is ________.
Answer: NEC Section 334.30
Question: Special occupancy areas are __________.
Answer: Area where sparks may cause a fire
Question: According to NEC Article 300, how far from the nearest edge must a hole be drilled in a stud if you are not using a nail plate?
Answer: 1.25"