Question: What is required for the field bending of PVC?

Answer: A heating unit

Question: A hickey is used to bend what?

Answer: RMC

Question: What is the key to accurate bending with a hand bender?

Answer: Constant foot pressure on the back piece

Question: In a right triangle, what is the side directly opposite the 90 degree angle called?

Answer: Hypotenuse

Question: Which two measurements must be known prior to making a 90 degree bend?

Answer: Stub-up and take-up distances

Question: What is a back-to-back bend?

Answer: Two 90 degree bends made back-to-back

Question: When making parallel offset bends, what additional information must be used to prevent the ends of the conduit from being staggered?

Answer: Center-to-center spacing and tangent of 1/2 the offset angle.

Question: When making a saddle bend, the center of the saddle will cause the conduit to shrink how much for every inch of saddle depth?

Answer: 3/16

Question: When using a pipe cutter, you should start the cut by rotating the cutter in which direction?

Answer: In a counterclockwise direction

Question: Is EMT threaded using a die?

Answer: No